Mar 13, 2019 Leave a message

Rolling Bearing Assembly Correctly

Rolling bearing assembly correctly

There are two main problems in the assembly of rolling bearings. One is the cleaning method of the bearing, and the other is the mounting method of the bearing. Experience has shown that bearing cleaning and installation methods have a large impact on the noise and vibration of the motor. Proper cleaning and installation methods can reduce motor vibration and bearing noise. Incorrect cleaning and installation methods are often the main cause of vibration, noise, bearing damage, or reduced service life. Therefore, the rolling bearing cleaning and installation must be carefully and carefully carried out in the correct way.

1. Preparation before assembly

1.1 The site where the bearing is assembled should be cleaned to prevent dust or small particles from entering the bearing.

1.2 Check the geometrical tolerance of the shaft, which does not meet the requirements and cannot be assembled. Also check the fillet size at the root of the shoulder and the perpendicularity of the shoulder to the shaft. Generally, the fillet radius of the root of the shoulder should be smaller than the radius of the fillet of the inner ring of the bearing, so that the bearing can abut the shoulder.

1.3 Parts assembly surface should be cleaned with gasoline or kerosene. No rust, spots or solid particles are allowed.

2, the bearing set process

There are two methods for assembling the bearing and the shaft: hot jacket and cold jacket. However, the hot sleeve is generally used because the inner ring of the bearing and the journal are generally over-fitted, and it is easy to put on after heating.

2.1 oil heating method

The oil heating method is to heat the inner ring of the bearing or the separable bearing into a fuel tank containing transformer oil, the temperature of the oil is 80-100 ° C, and the heating time is 20-40 min. In order to prevent the bearing from being partially heated and depositing impurities into the bearing, the oil surface should be covered with no bearing, and there should be a wire mesh frame at 50-70 mm from the bottom of the box, and the bearing is placed on the wire mesh frame. In addition, a thermometer must be suspended in the fuel tank to strictly control the temperature of the oil.

When the jacket is hot, take out the heated bearing from the fuel tank, and immediately wipe off the oil traces and attachments attached to the bearing surface with a lint-free white cloth. Then use a cloth pad, flatten the ends of both hands, align the shaft, and flatten. Push to the shoulder. If the sleeve does not go in, it may be too slow, the bearing has cooled, or the bearing is not equal. At this point, the copper sleeve can be used to hold the inner ring of the bearing and tapped gently with a hammer. After the bearing is set, remove the transformer oil from the bearing and add the grease of the motor name label. Generally it is between 1/3-2/3 of the bearing chamber volume, not too much or too little. Too much will cause the bearing to heat up and leak, too little will accelerate the bearing wear and make a big noise.

2.2 bearing cold pressing method

Cold press is to press the bearing smoothly onto the shaft with a press at normal temperature. When pressing, the center line of the press shaft should be coincident with the bearing shaft line to prevent the bearing from being skewed. Moreover, the pressure can only be applied to the inner ring of the bearing and not to the outer ring or the cage.

2

Send Inquiry

whatsapp

teams

E-mail

Inquiry