Motor bearing failure treatment
The bearing is an important part of the motor operation. According to many years of maintenance experience, the author knows whether the maintenance and maintenance of the bearing directly affects the service life of the bearing and directly affects the safe and efficient operation of the motor. Therefore, it is necessary to do a good job of maintenance work on a regular basis, according to the fault phenomenon that occurs, and deal with it in time to avoid the expansion of the fault; thus avoiding the burning of the motor and causing greater economic losses.
Second, how to clean rolling bearings
Bearings must be carefully cleaned prior to assembly. The cleaning agent is typically gasoline or kerosene. The purpose of cleaning is to:
1. Wash off the rust inhibitor on the bearing.
2. Wash off the dirt and debris that may enter the bearing due to carelessness. Bearings with dust caps or seals on both sides are supplied with lubricant before leaving the factory and should not be cleaned during installation.
Do not place the cleaned bearings directly on the workbench or in an unclean place. Use a clean cloth or paper pad under the bearings. Do not take it directly with your hands. It is best to wear canvas gloves that are not easy to remove hair.
Third, how to diagnose whether the rolling bearing is damaged and can continue to use
1. For small motors, manually move the shaft end of the rotor up and down. If the shaft can have a large amount of movement at this time, the bearing wear is serious.
2. Disassemble the end caps at both ends of the motor for inspection. If there is oil stain on the surface of the winding and the core, the bearing is leaking oil, and the seal is not strict or deformed.
3. After the bearing is removed, wipe off the grease in the bearing and wash the bearing with gasoline. Then the outer ring is shaken back and forth with respect to the ball by hand, and the gap of the good bearing is almost undetectable. If the gap between the ball and the inner and outer rings is large, the bearing is seriously worn and needs to be replaced.






