What should I do if the gear motor heats up?
As an indispensable power supplier in people's production and life, many gear motors have a very hot phenomenon in the process of use, but many times they don't know how to solve it. What is more serious is that they don't know why. The resulting motor heat, this should be the first to grasp the use of the motor, let's take a look at the common reasons why the motor is very hot.
1. The air gap between the stator and the rotor is very small, which easily leads to the collision between the stator and the rotor.
In medium and small motors, the air gap is generally 0.2 mm to 1.5 mm. When the air gap is large, the excitation current is required to be large, which affects the power factor of the motor; if the air gap is too small, the rotor may be rubbed or collided. Generally, due to the serious tolerance of the bearing and the wear and deformation of the inner hole of the end cover, the bottom of the base, the end cover and the rotor cause the broom, which is easy to cause the motor to heat or even burn. If it is found that the bearing wear should be replaced in time, the end cover is replaced or brushed, and the simpler treatment method is to insert the end cover.
2. The abnormal vibration or noise of the motor easily causes the heat of the motor.
This situation belongs to the vibration caused by the motor itself, mostly due to the poor dynamic balance of the rotor, as well as poor bearing, bending of the shaft, different ends of the end cover, the base and the rotor, loose fasteners or uneven grounding of the motor installation, and the installation is not in place. The result may also be transmitted from the mechanical end and should be excluded for specific circumstances.
3, the bearing work is not normal, it must be caused by the normal operation of the motor heating bearing can be judged by hearing and temperature experience.
The bearing end can be detected by hand or thermometer to determine whether the temperature is within the normal range; the bearing rod (copper rod) can also be used to contact the bearing box. If the impact sound is heard, it means that there may be one or several balls crushed, if heard The buzzing sound is that the bearing has insufficient lubricating oil, and the motor should be replaced with grease for about 3,000 hours to 5,000 hours.
4, the power supply voltage is high, the excitation current increases, the motor will be excessively hot
Excessive voltage can jeopardize gear motor insulation and expose it to breakdown. When the power supply voltage is too low, the electromagnetic torque will decrease. If the load torque is not reduced, the rotor rotation number is too low. At this time, the increase of the slip rate will cause the motor to overload and generate heat, and the long-term overload will affect the life of the motor. When the three-phase voltage is asymmetrical, that is, when the voltage of one phase is high or low, it will cause the current of a certain phase to be too large, the motor will heat up, and at the same time, the torque will be “beep” when the torque is reduced, and the winding will be damaged if the time is long.
In short, whether the voltage is too high, too low or voltage asymmetry will increase the current, the motor will heat up and damage the gear motor. Therefore, according to national standards, the motor power supply voltage should not change by more than ±5% of the rated value, and the motor output power can be maintained at the rated value. The motor supply voltage must not exceed ±10% of the rated value. The difference between the three-phase supply voltage should not exceed ±5% of the rated value.





