Dec 01, 2018 Leave a message

​ Inductive stepper motor

 Inductive stepper motor

1. Features: Compared with the traditional reactive stepping motor, the induction stepper motor has a permanent magnet on the structure to provide the working point of the soft magnetic material, and the stator excitation only needs to provide a changing magnetic field without providing The energy consumption of the magnetic material working point, so the motor is high in efficiency, low in current and low in heat generation. Due to the existence of permanent magnets, the motor has a strong back EMF, and its own damping effect is better, which makes it relatively stable during operation, low noise, and low frequency vibration. The inductive stepper motor can be regarded as a low-speed synchronous motor to some extent. A four-phase motor can be operated in four phases or in two phases. (Bipolar voltage drive must be used), while reactive motors cannot. For example: four-phase, eight-phase operation (A-AB-B-BC-C-CD-D-DA-A) can completely adopt the two-phase eight-beat operation mode. It is not difficult to find that the condition is C=, D=. The internal winding of the two-phase motor is exactly the same as the four-phase motor. The low-power motor is usually directly connected to two-phase, and the motor with larger power is used to flexibly change the dynamic characteristics of the motor for convenient use. (Four-phase), when used in this way, it can be used as a four-phase motor, and can be used as a two-phase motor winding in series or in parallel.

2. Classification: Inductive substepping motors can be divided into two phases: two-phase motor, three-phase motor, four-phase motor, five-phase motor, and so on. The frame number (motor outer diameter) can be divided into: 42BYG (BYG is the induction stepper motor code), 57BYG, 86BYG, 110BYG, (international standard), and like 70BYG, 90BYG, 130BYG are domestic standards.

3. Static index of stepper motor Terminus number: The number of pairs of excitation coils that generate different pairs of N and S magnetic fields. Commonly used m. Number of beats: The number of pulses required to complete a periodic change of the magnetic field or the conductive state is represented by n, or the number of pulses required for the motor to rotate through a pitch angle. Taking a four-phase motor as an example, there is a four-phase four-shot operation mode, that is, AB. -BC-CD-DA-AB, four-phase eight-shot operation mode is A-AB-B-BC-C-CD-D-DA-A. Step angle: corresponding to a pulse signal, the angular displacement of the motor rotor Expressed by θ. θ = 360 degrees (number of rotor teeth J * running beats), taking the conventional two-phase, four-phase, rotor teeth as a 50-tooth motor as an example. The step angle of the four-shot operation is θ=360 degrees/(50*4)=1.8 degrees (commonly known as the whole step), and the step angle of the eight-shot operation is θ=360 degrees/(50*8)=0.9 degrees (commonly known as Half step). Positioning torque: The locking torque of the motor rotor itself (caused by the harmonics of the magnetic field tooth shape and mechanical error) when the motor is not energized: the static torque of the motor under the rated static electricity, the motor does not rotate, the motor The locking torque of the shaft. This torque is a measure of the motor's volume (geometry) and is independent of the drive voltage and drive power. Although the static torque is proportional to the number of electromagnetic ampere-turns and the air gap between the fixed-tooth rotors, it is not advisable to reduce the air gap excessively and increase the static ampere to increase the static torque, which will cause the motor to Heat and mechanical noise.


Send Inquiry

whatsapp

teams

E-mail

Inquiry