Sixth, the simulation method of permanent magnet synchronous motor
1. The main problems that lead to deviations in performance and measured data are:
A. The material definition is imperfect
B. Actual size deviation
C. Insufficient estimation of material performance margin
D. Deviation caused by model equivalence
E. Deviation caused by unreasonable network division
F. Improper processing of simulation data
2. Precautions for simulation conditions:
A. Material properties
B. The variation of the iron loss table affected by the actual process
C. Meshing (many software is automatically divided)
D. Mechanical solver (understanding of MAXWELL force and virtual skill)
LD/LQ calculation and judgment
General rule: Ld increases with the weak magnetic speed and torque of the motor, and the value is basically unchanged. Lq decreases with increasing torque (or magnetic saturation) and increases with weak speed (lower magnetic density)
When the motor is subjected to FOC control, the AC current of the motor is simultaneously loaded. Under the same fixed rotor core magnetic circuit, the magnetic circuit of the straight axis is related. The simulation solution and loading conditions must be the same.
Seven, the design output parameters of permanent magnet synchronous motor
In the design of a permanent magnet synchronous motor, the following data must be counted:
Back EMF or no-load flux linkage (many data as a function of temperature)
Short circuit current (stable value equals no-load flux linkage / Ld)
Maximum phase current and maximum operating current frequency (consistent with controller IGBT)
Ld/lq table (corresponding to ID/Iq, both must be added at the same time)
Load characteristics (especially peak wheelbase, relationship between direct current and short circuit current)
Cogging torque
0N.m minimum phase current required magnetic flux distribution at the maximum speed (very important, the high speed of the electric vehicle is deep weakened, so the smaller the data, the more energy saving, the less the battery installation)
Efficiency MAP
Current density and heat load judgment
Slot full rate
Winding end size






