Spring Adjustment of discount 12 volt dc motor Controller
We believe that you will understand about DC motors, because the application of DC motors in life has become very common. The main part of the DC motor is the controller, which is the main part of the DC motor control speed. The speed control of DC motor controller is realized by the adjustment of spring. Specific actions:
First, disconnect the power, unplug the box machine, loosen the box cover screw, remove the box cover.
Second, the use of hexagonal wrench adjustment of each spring screw so that the DC motor controller in the rod operation to achieve the best results.
Third, if there is a jitter phenomenon in the time bar, the tension of the balance spring is too large and the above operation is repeated.
Fourth, connect the channel gate power supply, press the controller's <UNK> or <UNK> key, so that the DC motor controller runs 4 to 5 times up and down 90 degrees, such as the shaking phenomenon in the time bar of the falling rod, indicating that the balance spring tension is not enough, and the DC motor controller is operated. Vertical state.
Fifth, if the rod, the DC motor controller has the operation DC motor controller does not act, indicating that the balance pull spring tension is insufficient, adjust the pull spring state or increase the Galla spring, until the DC motor controller is operating normally.
