How the servo motor works
The working principle of the servo motor is relatively simple, but its work is more efficient. The servo circuit is built into the motor unit and uses a flexible shaft that is usually equipped with gears. The electrical signal controls the motor and also determines the amount of movement of the shaft. The internal setting of the servo motor is simple: small DC motor, control circuit and potentiometer. The DC motor is connected to the control wheel through a gear. When the motor rotates, the resistance of the potentiometer changes, and the control circuit can precisely adjust the motion and direction.
When the shaft is in the correct (ideal) position, the motor stops supplying power. If the axis does not stop at the target position, the motor runs until it enters the correct direction. The position of the target is transmitted through a signal line using an electric pulse. Therefore, the speed of the motor is proportional to the actual and ideal position. When the motor approaches the desired position, the motor begins to rotate slowly, but the speed is fast when the motor is turned to the farthest. In other words, servo motors only need to complete tasks as quickly as possible, which makes them an efficient device.
When there is no control voltage in the AC servo motor, only the pulsating magnetic field generated by the field winding is present in the air gap, and there is no starting torque on the rotor and it is stationary. When there is a control voltage and the control winding current and the field winding current are out of phase, a rotating magnetic field is generated in the air gap and electromagnetic torque is generated to rotate the rotor in the direction of the rotating magnetic field. However, the servo motor requirements can be started not only under the control voltage, but also after the voltage disappears, the motor should stop immediately. If the servo motor control voltage disappears and continues to rotate like a normal single-phase asynchronous motor, there is a loss of control. We call this phenomenon of self-rotation due to loss of control.
The basic working principle of the traditional DC servo motor is exactly the same as that of the ordinary DC motor. The electromagnetic torque is generated by the action of the armature current and the air gap flux to make the servo motor rotate. The armature control mode is usually adopted, that is, the rotation speed is adjusted by changing the armature voltage while keeping the excitation voltage constant. The smaller the armature voltage, the lower the rotational speed; when the armature voltage is zero, the motor stops. Since the armature current is zero when the armature voltage is zero, the motor does not generate electromagnetic torque, and there is no "rotation".
If you want to buy a food processing processor motor, please pay attention to kitchen appliances motor.





