high torque dc motor drive circuit
The performance of the DC motor drive circuit greatly affects the overall system performance. There are many issues that need to be carefully designed, such as conduction delay, pump lift protection, overvoltage and overcurrent protection, switching frequency, and choice of additional inductance.
The low power drive circuit can use the H bridge switch circuit as shown in FIG. UA and UB are complementary bipolar or unipolar drive signals with TTL levels. The withstand voltage of the switching transistor should be greater than 1.5 times Us. Since high-power PNP transistors are expensive and difficult to implement, this circuit is only used in low-power motor drives. When the four power switches are all NPN transistors, the base level shifting problem of the two upper arm transistors (BG1 and BG3) needs to be solved. The H-bridge switching circuit of Figure 2 implements the level shifting of the upper bridge transistor using two transistors. However, the loss on the resistor R is large, so it can only be used in low-power motor drives.
When the driving power is relatively large, the voltage of the common bridge arm is also relatively high, for example, the power frequency voltage is directly taken, single phase 220V, or three phase 380V. For safety and reliability, it is desirable to insulate the drive circuit (main circuit) from the control circuit. At this point, the main circuit must use a floating front drive. The floating front drive circuits shown in Figure 3 are independent of each other and are powered by separate power supplies. Since the optocoupler is used in the pre-driver circuit, the control signals are electrically insulated from the respective pre-drive circuits, thus causing the control signals to float (or not) to the main circuit.






