Jun 04, 2019 Leave a message

Four Solutions For Noise In Small Dc Motor

Four solutions for noise in small dc motor

Whether it is a geared motor or a small dc motor, it will produce unpleasant noise after a long period of use. This causes a lot of reasons, most of which are caused by damage to the internal parts of the DC motor. currently using. Then, in the following, we will elaborate on four solutions for noise in DC motors.

1. Geometrical accuracy adjustment of components Because the geometric accuracy of the installation does not meet the requirements of the standard, the components of the reducer resonate and cause noise. This should improve the installation process, increase the tooling, and ensure the overall quality of the assembly personnel. relationship.

2. The loose parts of the DC motor are loose during assembly, resulting in inaccurate system positioning, abnormal position meshing, shafting movement, vibration and noise. This series needs to proceed from the design structure to ensure each The connection of the mechanism is stable and a variety of connection methods are adopted.

3. Vibration reduction and blocking measures When installing the reducer, it should try to avoid resonance between the fuselage and the basic support and the connecting parts, and generate noise. One or several gears often occur inside the 24 volt DC motor. Resonance occurs in the speed range. In addition to the design reasons, there is a direct relationship between the installation of the resonance position and the corresponding vibration reduction or blocking measures. Some reducers that require low transmission noise and vibration should be selected. High toughness, high damping base material to reduce noise and vibration.

4. Damage to the transmission components During the installation, the transmission components are damaged due to improper operation, resulting in inaccurate motion or motion instability. The high-speed moving parts are damaged by the oil film due to damage; the moving parts are artificially unbalanced; both generate vibration and noise. The reason is to pay attention to and avoid as much as possible during the installation process, and replace the damaged parts that cannot be repaired to ensure the system obtains a stable noise level.

TW-DC280


Send Inquiry

whatsapp

teams

E-mail

Inquiry