China Smart Meter Motor suppliers, China Smart Meter Motor suppliers,Teamwork Global Group, the following is the deceleration motor precautions. 1. The hammer strike is strictly prohibited. 2. The output shaft of the reducer is installed. When the coupling, pulley, sprocket and other couplings, direct hammer is not used. Because the output shaft structure of the reducer cannot withstand the axial hammer, screw into the screw to suppress the coupling. 3. Be sure to install the ventilation cap (exhaust plug) before use, the highest blockage at the exhaust plug should be replaced to ensure that the reducer exits the body gas when running.If it is not replaced in time, the reducer runs for a long time, and the gas in the reducer will seal the oil expansion is bad, and even the reducer oil leakage. 4. Replace the lubricating oil in time, and pay special attention to the first time. Special attention should be paid to the first oil change. The reducer should replace the lubricating oil in time after the first running of 300 —— 400 hours, and replace the lubricating oil every 1500 —— 2000 hours later.Gearbox cleaning machine uses the original gearbox feeding oil exhaust system and filtered old oil can realize the gearbox cleaning, waste oil rapid filtration, filling with new oil and other functions, the operation process does not change the hardware facilities, do not add cleaning agent, to ensure the safe operation of the gearbox, prolong the service life.In addition, in the harsh working environment, high temperature, large dust under the lubricating oil should be checked every half a month, found that the lubricating oil is dirty to replace the lubricating oil, in order to keep the lubricating oil clean, prolong the service life of the reducer, improve economic benefits.
