Oct 18, 2022 Leave a message

Working principle and matters needing attention of shaved ice machine

Shaved ice machine is also called ice crusher, smoothies, shaved ice is ice shaver into snow crushed ice equipment, the condensed milk, syrup, combined with fruits or other ingredients, if hawthorn tablets, raisins, chocolate, red bean paste, green bean paste, ice cream, etc, made of high-grade cold drink, taste and delicate, the entrance slag, sugar, summer cooling efficiency is very high, eat there won't be full Feeling. Shaved ice machine is widely used in the catering industry, cold drink shops, western restaurants, coffee shops, leisure snacks and hotels and other industries, is a common cold drink equipment to manufacture ice drinks, used to produce a variety of taste, a variety of different flavors of shaved ice food.

The working principle of

First break the ice to a diameter of about 20 mm, then put into the cylinder, the upper side of the convex cylinder is appropriate. Note that the power switch is turned on first, and then the handle of the dynamic press cover of the plate is pressed down after the motor rotates with the power plate. At this time, the ice cubes are chopped by fastening the blade on the rotary knife plate. However, when the handle of the press cover is pressed down, it shall not be too hard to prevent the motor from blocking and damaging the motor. If it is a fully automatic shaved ice machine, just put the appropriate ice, cover the machine, open the switch can be. During operation, attention should be paid to the surplus after the reduction of ice, and the new ice block should be added in time.

Precautions for Use

Used for mincing ice particles, through the discharge port into the tray, we should pay attention to the discharge port discharge smoothly, can not be blocked, otherwise it will cause stuck knife head, burn out the motor. If the cutter head is found to be stuck, immediately lift the handle of the press cover, turn off the switch, pull out the plug, and troubleshoot the fault in time.

Ice thickness can be by adjusting the blade mouth bulging disc height, shaved ice machine need to adjust the corresponding thickness switch can, if it is semi-automatic, to view the instructions, have a plenty of cannot open adjustment, such as you can, when need to adjust to remove the protection switch device of plastic tray, loosen screw fixed bend, pull out the cylinder, then the pine plates of the operation Tighten the screw, remove the cutter head, then loosen the pressing screw of the blade, according to the required requirements, install in place, and then put the cutter head back in place in order. The design transient rate of the motor is 80%, to avoid long time continuous operation. After working continuously for one hour, you should stop for twenty minutes before you start working. This will greatly extend the service life of the motor. After each use, it must be cleaned. When cleaning, it should turn off the main power switch, unplug the plug, and then wipe the water on the machine with a clean towel.

After cleaning, be sure to lift the handle of the press cover. Cleaning agents are not allowed to be used during cleaning to prevent contamination caused by residual cleaning agents on board. Also can not be directly washed with water, so as not to damp electrical parts, affect the safe use and damage the machine.

Whether cleaning, maintenance, blade replacement or cleaning ice slag and other related work, should first turn off the power, unplug the power plug; Shave ice is not allowed to run for a long time without load.

TW-49TYZ

Send Inquiry

whatsapp

teams

E-mail

Inquiry