What are the fault handling solutions for power generation welding machine?

What are the fault handling solutions for power generation welding machine?

What are the fault handling schemes for the power generation welding machine? The fault handling scheme for the power generation welding machine is as follows: Case 1 The engine does not start, is there enough fuel? Is the fuel valve open? Does the fuel reach the carburetor? When the fuel valve is open, check by removing the drain screw on the bottom of the carburetor. Note: If fuel spills, be sure to dry the spark plug before testing it and starting the engine. Otherwise the spilled fuel or oil vapor may be ignited.

Is the engine at the beginning of the ON position? Is there enough oil in the crankcase? Does the spark plug have sparks?

(1) Under the spark plug cap. Clean the dirt around the spark plug and then pry off the spark plug.

(2) Install the spark plug on the spark plug cap.

(3) Turn on the engine switch (ON) position

(4) Ground the spark plug side electrode to the engine, pull the recoil starter, and check whether the spark is jumping.

(5) If there is no spark, disconnect the oil protector and re-pull the recoil starter. If there is still no spark, replace the spark plug. If there is a spark, please start the engine according to the instructions.

Case 2 Generator voltage output is abnormal Check if the generator rotor center fastening bolt is loose. Check if the engine speed is normal. Case 3 For other questions, please ask the manufacturer or send it to our special dealership for repair.