Sweeper motor, sweeper motor, scrubber motor application solution.
Common faults and solutions for vacuum cleaners:
First, the noise is large. Cause of formation: It may be that the blockage is sucked, causing the suction to decrease and the noise becomes louder! Serious bearing wear, bending of the shaft, deformation or displacement of the impeller shaft, loose fasteners, etc.
Solution: Simply disassemble, check whether the parts are loose or remove foreign objects, and then tighten! Apply oil to the Sweeper motor.
Second, the motor does not turn. Causes of formation: burnt or worn out of the brush, poor contact between the plug and the socket, damage to the vacuum cleaner switch, broken fuses, etc. Solution: It is recommended to contact the seller, repair point inquiry!
Third, the motor is overheated. Causes of formation: continuous working time is too long, the brush and commutator wear excessive sparks, the dust ash on the dust filter is too much, and the dust collecting chamber is full of ash.
Solution: It is recommended that the vacuum cleaner should not be used for a long time. It is best not to exceed 1 hour! The vacuum cleaner motor is similar to a car engine, and it will heat up when it is opened! The car has water cooling, and the vacuum cleaner motor is not. It is recommended to take a rest for 1 hour. Or often clean and maintain the parts of the vacuum cleaner!
Fourth, the suction decreased. Causes of formation: motor failure, brush wear, dust filter damp, dust collection chamber dust, hose and suction port or exhaust port blockage, pipe leak, poor interface seal, etc.
