Mar 09, 2020 Leave a message

Step by step to teach you the classification of DC motor used in food Processing Motor factory

Step by step to teach you the classification of DC motor used in food Processing Motor factory

2. The DC motor used shall be classified according to whether there is permanent magnet or not

According to whether there is permanent magnet or not, the motor can be divided into water magnet motor and series excitation motor.

(1) Permanent magnet motor

Permanent magnet motor is its rotor or stator has only one winding made of enameled wire (commonly known as wire wrap), and the other one uses permanent magnet (also known as magnet steel). Permanent magnet motor is divided into two categories: brush motor and non brush motor.

(2) Series motor

Series excitation motor does not use magnet, rotor and stator adopt winding respectively, and these two windings are used in series, so this kind of motor is called series excitation motor. Among them, the magnetic field produced by stator winding is called exciting magnetic field

The connection of series excitation motor and control element is also two lines, but the rotation direction of motor can not be changed by exchanging wires like permanent magnet brush motor, but by exchanging rotor winding (one pair of wires) or stator winding (one pair of wires).

 

3. DC motor used shall be classified according to speed

According to the speed, the motor can be divided into high speed and low speed. The motor whose speed is higher than 3000 / min is called high-speed motor, and the motor whose speed is lower than 1000 / min is called low-speed motor. At present, the brush toothless hub motor can achieve about 200R / Mn. Because the speed of high-speed motor is 3000-5000 / min, the electric bicycle needs:

(1) The speed of high-speed motor is about 200 / min. in order to realize stepless speed regulation of 0 ~ 20km / h, it is necessary to decelerate through gears and clutches, so high-speed motors are all toothed motors. Some high-speed motors are installed separately from the reduction gear, while others install the gear inside the motor. If there is a brush toothed hub motor, the reduction gear is installed inside.

The above is the classification of DC motor used in food machinery factory. I hope it can help you.

 

TW-DC4030

Send Inquiry

whatsapp

teams

E-mail

Inquiry