At present, there are too many food machinery factories. Taking Zhucheng as an example, there are many packaging machinery factories, mezzanine pot factories, rolling and kneading machine factories, fryer factories, cleaning equipment factories, etc. These food machinery factories use DC motor when they produce equipment. The classification of DC motor is as follows.
1. The DC motor used shall be classified according to whether there is brush or not
Brush or no brush is the abbreviation of brush or no brush. The continuous rotation of DC motor depends on the same repulsion and opposite attraction of rotor magnetic field and stator magnetic field. The current flowing through the winding should be converted at a proper time, otherwise the rotor cannot rotate normally.
(1) Brush motor
A brush DC motor is a DC motor that uses a brush (commonly known as a brush). The brush motor realizes the alternating conversion of current polarity by the cooperation of commutator (commonly known as commutator) and brush, and the commutator and brush are installed inside the motor. The brush motor is divided into high speed and low speed. There are only two outgoing lines for the brush motor.
The main reasons for the high failure rate of the brush motor are as follows: first, the brush is easy to be ignited due to wear; second, the magnetic steel has poor heat dissipation conditions and is easy to demagnetize. Brush wear is not only related to time, but also to current and brush gold content, so most brushes have a service life of about 200. Because of the large current, it is easy to replace series excited motor when its service life is less than 200, but it is more difficult to replace hub motor and post motor (also called Center Motor).
(2) Brushless motor
A brushless motor is one that does not use a brush. In order to realize commutation, the transistor and position sensor (Hall element) are used instead of the brush and commutator. Because the brush and commutator are eliminated, the electromagnetic interference is eliminated, the mechanical noise is reduced, and the service life is prolonged. However, the control elements (motor drive, control circuit) of this kind of motor are relatively complex, which increases the cost, and there is slight jitter when starting at low speed.






