Mobile dust collector, for the general small proportion, fine metal chips, casting sand dust, cement, gypsum powder, carbon powder, rubber powder, plastic powder in a certain range of sand also have a good dust removal effect, dust removal efficiency is greater than 99.5 percent. The dust gas is drawn into the box by the fan through the vacuum pipe and enters the filter bag. The dust particles are kept on the surface by the filter bag. The filtered purified gas is discharged from the air outlet, which can be directly discharged for indoor circulation or discharged outdoors according to the needs. The whole dust filter is the result of a comprehensive effect of gravity, inertial force, collision, electrostatic adsorption and filtration. After the dust collector works continuously for a period of time, the dust on the surface of the filter bag keeps increasing, and then the dust is cleared. The dust shakes off in the dust collector (drawer), and then it is treated manually. Flexible and convenient, local dust collection, local treatment, can effectively ensure the cleanliness of the air, the products are novel, beautiful, practical, stable performance, convenient to use and maintenance.
1. The selected dust collector must meet the emission concentration specified in the emission standard
2. The physical properties of the dust have a great influence on the performance of the dust collector
3. Dust-bearing concentration of the gas
When the dust-containing concentration of the gas is high, the initial purification equipment with low resistance shall be set up before the electrostatic precipitator or the bag dust collector to remove the coarse dust particles
4. Gas temperature and other properties are also the factors that must be considered when selecting dust removal equipment
I Bag dust collector should not be used for high temperature and high humidity gas
The flue gas also contains at the same time SO2, NO and other gas
Reasonable selection of dust collector 2
Reasonable selection of dust collector 2
State pollutants, can be considered to use the wet dust collector, but attention must be paid to the corrosion problems
5. When selecting the dust collector, the treatment of dust capture must be considered simultaneously
6. Other factors
I Location of the equipment, available space, and environmental conditions
Reasonable selection of dust collector 3
Reasonable selection of dust collector 3
One equipment investment (equipment, installation, engineering, etc.) and operation and maintenance costs.
