China DC motor suppliers, reducing motors are currently more and more, and everyday may encounter an abnormal situation in the speed reduction motor. Let's take a look at the exceptions of daily.
1) Tanker Motor FAQ: 1. The gear case motor is used for initial use. It cannot be activated. 2. There is a hitting sound inside the gearbox motor.
2) Reasons and solutions: 1.1 Due to low temperature or other reasons, the fluidity of the bulk internal lubrication is deteriorated, and the instantaneous current is raised, thereby causing the transmission overload protection, and can start more time. 2 There is a gear wear iron cut in the gearbox motor, and it needs to be removed or replaced by the internal gear at this time. 2. Internal planet racks, internal gear friction generates iron cut, which is required to change the reducer. 3. Output terminal bearing, deformation, or wear, at this time, it is necessary to switch the mounting bearings and check that there is no wear and cracking in the internal gear. 4. This situation is a common condition, mostly due to excessive lubricants, and there is no such situation. 5.1 Deceleration machine overload operation, output shaft will be partially broken due to fatigue, according to the manufacturer's designated requirements, can reduce such accidents to a large extent.
2 The output shaft is uneven, and the radial load is exceeded, or it works for a long time in the rated vigor.
At this time, you need to check if the load exceeds the rated range. If so, you need to change a larger type gearbox motor.






