China printer motor factory, provide various types of motor, powder motor does not turn for the following reasons:
1, single-phase capacitor motor failure solution: 1, first check the mechanical parts 2, check the capacitor, the reason is that the capacitor capacity becomes smaller 3, check the winding. It's not easy to check. It can be disassembled to check whether the winding is burning or not
2. Check whether the stator and rotor have swept the bore. 3. Check whether the stator and rotor have short circuit.
Printer rollers damage may be the cause of the paper output path with debris, such as parts of the feed roller rotational failure, the cartons into the paper, sensor fault, such as ways to eliminate this kind of failure is very simple, just open the machine cover and remove the card paper, but should pay attention to, must be take paper feed direction, must not turn any switch in the opposite direction. If the paper is often jammed, it is necessary to check the paper inlet channel, remove debris from the output path, and the front edge of the paper should be just above the metal plate. Check whether the paper roll is worn or the spring is loose, the pressure is not enough, that is, the paper can not be fed into the machine. When the paper roller is worn and cannot be replaced, the method of winding rubber band can be used for emergency treatment. After winding the rubber band, the friction force of rubbing paper is increased, and the paper can be restored to normal. In addition, the installation of paper plate is not normal, the quality of paper is not good (too thin, too thick, damp), will also cause the failure of paper jam or can not take paper.






