Analysis of two noise and noise reduction measures of the motor
2, aerodynamic noise
The aerodynamic noise of the motor is eddy current noise and flute noise.
Eddy current noise is mainly caused by alternating eddy currents of cooling air caused by the rotor and the fan on the rotating surface. The flute noise is generated by compressing air or by rubbing air over a fixed obstacle. The flute noise in the motor is mainly caused by the radial ventilation groove. The whistling noise is enhanced by the reduction of the gap between the rotating member and the fixed member. Therefore, the sealed soundproof cover is used to "seal" the noise in the soundproof cover, increase the gap between the rotating part and the fixed part, improve the shape of the air hood, and use the uneven distribution and the length of the unequal distance to reduce the flute. An effective way to sing noise. In addition, reducing the circumferential speed of the rotor surface and reducing the surface area of the motor and the surface roughness of the rotor can also reduce aerodynamic noise.
3, commutation noise
Commutation noise, also known as brush noise.
In motors with slip rings and commutators, commutation noise is unavoidable and sometimes becomes a major source of noise. Commutation noise is caused by three reasons:
Friction noise
The frictional connection between the brush and the slip ring and the commutator inevitably produces frictional noise. The magnitude of the frictional noise is related to the state of the slip ring and commutator surface, the friction coefficient of the brush, the absolute humidity of the air, and the brush pressure. Therefore, the method of reducing friction noise is: improving the working surface smoothness and roundness of the slip ring and the commutator; ensuring that the absolute humidity of the air is not less than 5 g/m3; cleaning the brush surface; the hardness of the brush material cannot be too large; Reduce the diameter of the commutator.
Impact noise
This is because there is a mica groove between the commutator segments. Due to the deformation of the commutator, the mica groove undercut and chamfering process is not good, so that the brush will often hit the commutator when the motor rotates, so that the commutator and Reduce this noise.





