Analysis and solution of common faults of spindle motor
Briefly describe the common four types of fault analysis of woodworking engraving machine spindle motor and its solution
First, the woodworking engraving machine spindle motor is hot:
Solution: First check if the pump is working, and if you want to see if the circulating water is low.
Second, I feel that the motor has no strength and can't turn:
Solution: Check the circuit to check if the motor line is out of phase or if the cable is shorted.
Third, the motor makes a strange sound:
Solution: Check if the motor is overloaded; there may be a fault inside the motor, and it should be repaired or replaced in time. ---Woodworking engraving machine
Fourth, the motor reverse:
Solution: Check directly if the motor line is out of phase or swap the output UVW end.
5. The woodworking engraving machine has one axis that does not rotate:
Check whether the drive block corresponding to the corresponding axis of the woodworking engraving machine is damaged;
The check steps are as follows:
1. Unplug the aviation plug corresponding to the fixed shaft of the woodworking engraving machine;--Woodworking engraving machine
2. Then insert it into the drive corresponding to the movable shaft and observe the phenomenon. If the motion description is normal; if it does not move, it means that the cable or the motor is faulty. If it needs to be replaced in time, it means that the driver block corresponding to the axis of the woodworking engraving machine is damaged, and the driver block needs to be replaced.
