Vacuum Cleaner Motor factory direct quality suppliers
Motor factory for household vacuum cleaner
There are copper wire motor and aluminum wire motor.
Copper wire motor has the advantages of high temperature resistance, long service life, long single operation time, etc., but the price is higher than aluminum wire;
Aluminum wire motor has the characteristics of low price, but poor temperature resistance, low melting point, life is not as long as copper wire.
The series wound motor is mainly composed of stator, rotor, front and rear end covers (covers) and cooling wind blades.The rotor is composed of rotor core, shaft, armature winding and commutator. Its function is to ensure and generate continuous electromagnetic torque, drive the load to do work by rotating the shaft, and convert electrical energy into mechanical energy.The front and rear enclosures are used to support the armature and to secure the connection between the stator and rotor. The rotating shaft and the front and rear enclosures should be strong enough to prevent the armature from resonance with the enclosures, causing vibration and danger. Generally, there are rolling or sliding bearings in the front and rear enclosures.
Avoid dust damage to motor.It should not be used for a long time. If the dust accumulates on the filter bag after a period of time and causes the suction to drop, the box can be shaken at this time. The dust is shaken and falls on the bottom of the box.If there is too much dust in the vacuum cleaner bag or bucket, remove the dust as soon as possible and keep the bucket clean, so as not to affect the vacuuming effect and the heat dissipation of the motor.Abnormal noise occurs when vacuuming, or not vacuuming, to check in time, or send to place the vacuum cleaner to pay attention to, in the dry place.Do not wipe the switch with wet cloth when cleaning, otherwise it may cause electricity leakage or short circuit.The motor has overheat power off protection function, this is the machine self protection, is not what the problem.After the machine is opened, the motor runs at high speed (about every second), it will produce a certain amount of heat. Under normal circumstances, the temperature rises to about degrees, and the protection temperature is two minutes continuously.
