Aug 07, 2019 Leave a message

Structure Optimization And Characteristics Of China Automotive Dc Motor

Structure optimization and characteristics of China Automotive Dc Motor

First, the characteristics of small speed regulating Motors:

The small speed regulating motor is a kind of machine that can reduce the speed according to the principle of little tooth difference planetary transmission. The machine has such characteristics as large transmission ratio, small volume, high efficiency, low noise, steady transmission, long life, coaxial output, etc.. It is the preferred equipment for metallurgy, mining, construction, chemical, textile, light industry and other industries.

Current structure of small speed regulating motor

1. Machine seat

The coaxial degree of the axis of the bearing hole and the needle tooth shell with the stop is not less than 8; The vertical degree of the two bearing holes at the end of the joint with the needle tooth shell is not less than level 6.

2. Needle shell

The diameter tolerance of the center circle of the needle tooth is J7 or js7; The vertical degree of the axis of the pin pin hole with the flange end cover is not less than level 6; The radial beating of the center circle pair with flange end cover does not fall below level 7; The coaxial degree of the coaxial axis of the flange end cover is not less than 8; The parallelism of the two ends of the needle shell is not less than level 7; There are strict regulations on tolerance and tolerance accumulation error of adjacent hole margins in needle pin holes:

In addition to the machining error of the small speed regulating motor and the needle tooth shell, there are also assembly errors between them. The processing of needle and tooth pin holes is one of the most difficult parts of the small speed regulating motor parts. At present, most of them are carried out on the vertical drill using precision division platforms. The locksmith completes the work. This is a very low production efficiency and requires special fixtures. In addition, The axial fixation of the output(human) axis, the combination of the fastening ring and the output shaft adopts the temperature difference method to assemble, the assembly is inconvenient, it is not suitable for modern scale production, and special heating equipment is also required; Between the two bearings, an isolation sleeve is added, and the restricted bearings are positioned with a deep groove ball bearing with a stop groove. The outside is fixed with a pressure cover, and the feeling is not simple and clear enough.

TW-DC750PM

Send Inquiry

whatsapp

teams

E-mail

Inquiry