Jan 21, 2019 Leave a message

Stepper Motor Construction

Stepper motor construction

As shown in Figure 1, the stepper motor is driven by a set of coils wound around the stator of the motor, the stator slot. Usually, a wire wound in a loop is called a solenoid, and in a motor, a wire wound around a tooth is called a winding, a coil, or a phase. If the current flow in the coil is as shown in Figure 1, and we look down the top of the tooth slot from the top of the motor, the current flows counterclockwise around the two slots. According to Ampere's law and right-hand rule, such a current produces a magnetic field in the north pole.

Now suppose we construct a motor with two windings wound around the stator, with a permanent magnet that can rotate freely around the center. This rotatable part is called the rotor. Figure 2 shows a simple motor called a two-phase bipolar motor because it has two windings on its stator and its rotor has two magnetic poles. If we deliver current to winding 1 in the direction shown in Figure 2a, and no current flows through winding 2, then the south pole of the rotor of the motor will naturally point to the north pole of the stator field as shown.

Assuming that we cut the current in winding 1 and deliver current to winding 2 in the direction shown in Figure 2b, the magnetic field of the stator will point to the left and the rotor will rotate with it, consistent with the direction of the stator field.

Next, we cut off the current of winding 2 and deliver current to winding 1 in the direction of Figure 2c. Note that the current flow in winding 1 is opposite to that shown in Figure 2a. Then the north pole of the stator's magnetic field will point downward, causing the rotor to rotate and its south pole pointing downward.

Then we cut off the current in winding 1 and deliver current to winding 2 in the direction shown in Figure 2d, so that the stator magnetic field points to the right again, causing the rotor to rotate and its south pole to point to the right.

If the current is delivered to both windings at the same time, the torque of the motor can be increased, as shown in Figure 4. At this time, the magnetic field of the stator of the motor is the vector sum of the magnetic fields generated by the two windings. Although this magnetic field only rotates the motor by 90° every time, as in Figure 2 and Figure 3, because we simultaneously excite two Motor windings, so the magnetic field at this time is stronger than when a single winding is excited separately. Since the magnetic field is the vector sum of the two vertical fields, it is equal to 2 x 1.414 times of each field alone, so that the torque applied by the motor to its load is also proportionally increased.

TW-ST28HS

If you want to buy a fan motor, please pay attention to Industrial Fan Motor.

Send Inquiry

whatsapp

teams

E-mail

Inquiry