New Technology Of Cheap Long Life Dc Motor Armature Roll Paint - News

New technology of cheap Long Life Dc Motor armature roll paint:

1, armature winding roll paint process, micro-motor motor armature automatic roll paint process in addition to the upper and lower materials, the rest through the chain drive mechanism in the closed channel automatically completed. The process is compact, takes a short time, has a faster production cycle than manual operations, and reduces the area of equipment and work space. The toxic gas produced during the work is extracted from the air duct and discharged after treatment.

TW-7712

After the armature is installed by the worker on the transmission chain, it is first heated and baked by an electric heat pipe in the channel. The temperature before and after the channel is different, and self-moving detection and control are implemented. After baking, the armature enters the insulating paint groove. The height of the liquid surface of the paint in the groove is adjusted according to the diameter of the armature. There is a paint filling device above the paint groove. When the liquid surface of the paint is reduced, the paint can be recycled. The armature rotates on its own in the paint tank and implements the paint rolling process. After rolling for a week, it leaves the paint tank. The excess paint drops on its own, falls into the tank, and re-enters the paint tank for reuse. The automatic lifting and lifting of paint tank is controlled by hydraulic transmission. After the varnish drops on the armature, it condenses and solidifies in the channel. After the transmission chain takes the armature out, the roll paint process has been completed. After the operator removes the armature, if there is a lacquer tumor at the first round shaft outside the center of the iron, the entire armature paint process will be completed. The entire process is only about 2 min, which is 3 to 4 times more efficient than manual roll paint.
3, the characteristics of the armature roll paint process micro-DC motor armature roll paint process automatic control by the microcomputer roll paint treatment of various processes, the implementation of fixed time, fixed temperature, fixed paint groove height, according to the parameters specified in the process, which eliminates the subjective arbitrary. Ensure product quality. In the process of rolling paint, PTFE protective sleeve is installed on the axis of the armature of the toy electric machine, and only the armature iron center is immersed in the paint surface, and the changer is still above the paint liquid surface, which solves the problem of cutting the groove under the changer. Paint this technical problem.
The armature roll paint process shortens the production cycle and automatically operates continuously. The entire process is only 1 time for the upper and lower workpieces, reduces the number of moves, avoids the collision damage of the armature, improves the product acceptance rate, reduces the labor intensity of the workers, and increases productivity. Reduced costs. The entire process of rolling paint is done in a closed channel, and there are wind ducts that remove toxic volatile gases from the treatment and discharge them. The workshop is no longer filled with benzene gases, which greatly improves the working environment and is beneficial to workers 'physical and mental health. It is a green ring protection technology reform measure; The technology of the micro-DC motor armature roll paint is controlled by microcomputer. Among them, temperature control is divided into two areas, preheating area and rolling immersion curing area. Alarm devices in excess of the prescribed temperature and stop immediately. There are also motor overload protection, heater and fan interlock control, self-moving power outage and other protection measures, which ensures the safety of production.