Motor and pump bearing temperature standards
Considering the ambient temperature of 40 °C, the maximum operating temperature of the motor should not exceed 120/130 °C. The bearing temperature is up to 95 degrees.
First, the bearing temperature standard - pump bearing temperature standard
1. GB32154.4.1 During the working period of the pump, the maximum temperature of the bearing does not exceed 80 °C
2, JB / T52943.2.9.2 bearing temperature rise must not exceed the ambient temperature of 40, the maximum temperature must not exceed 80 ° C
3. When JB/T64394.3.3 is operated under the specified working conditions, the temperature of the outer surface of the built-in bearing should not be higher than the temperature of the conveying medium by 20 °C, and the maximum temperature is not higher than 80 °C. The external surface temperature rise of the externally mounted bearing should not be higher than the ambient temperature of 40 °C. The maximum temperature is not higher than 80 ° C
4, JB / T72555.15.3 bearing temperature. The bearing temperature rise must not exceed the ambient temperature of 35 ° C, the maximum temperature must not exceed 75 ° C
5, JB/T77437.16.4 bearing temperature rise must not exceed the ambient temperature of 40 ° C, the maximum temperature must not exceed 80 ° C
6, JB/T86444.14 bearing temperature rise must not exceed the ambient temperature of 35 ° C, the maximum temperature must not exceed 80 ° C
Second, the motor bearing temperature regulations, the cause of abnormalities and treatment
The regulations stipulate that the maximum temperature of the rolling bearing does not exceed 95 °C, and the maximum temperature of the sliding bearing does not exceed 80 °C. And the temperature rise does not exceed 55 ° C (temperature rise is the bearing temperature minus the ambient temperature at the test);
(1) Cause: The shaft is bent and the center line is not accurate. Handle; find the center again.
(2) Reason: The basic screw is loose. Handling: Tighten the foundation screws.
(3) Reason: The lubricating oil is not clean. Treatment: Replace the lubricant.
(4) Reason: The lubricating oil has been used for a long time and has not been replaced. Treatment: Wash the bearings and replace the lubricant.
(5) Cause: The ball or roller in the bearing is damaged.
Handling: Replace the new bearing. According to the national standard, the F-class insulation B-level assessment, the motor temperature rise is controlled at 80K (resistance method), 90K (component method). Considering the ambient temperature of 40 °C, the maximum operating temperature of the motor should not exceed 120/130 °C. The bearing temperature is up to 95 degrees. The temperature of the bearing outdoor surface is measured by an infrared detecting gun. Empirically, the maximum temperature of the 4-pole motor cannot exceed 70 °C. For the motor body, no monitoring is required. After the motor is manufactured, in general, his temperature rise is basically fixed and will not change or grow with the motor operation. The bearing is a consumable part and needs to be tested.
