Electric doors are often used in life. Especially for some companies. Do you see why electric doors open and close by themselves? The reason is that it has an electric motor. Installing the electric door motor - Method of installing the electric door motor
1, positioning, line: fixed glass and mobile glass door combination glass door, unified line positioning, according to the design and construction drawings, release the positioning line of the glass door, and determine the position of the door frame. On both sides of the top limit slot and the bottom support slot, as well as the thick glass and frame column on the seam and other cracks, inject glass glue sealing, scrape off the excess glass glue with tools.
2. Limit slot on the top of the installation frame: the width of the limit slot should be greater than the thickness of the glass by two to four millimeters, and the depth of the slot is ten to twenty millimeters. When installing, at the beginning of the play in the line leads to two metal decorative plate edge, then according to the edge of the door frame top limit slot installation, through the adhesive plate to adjust the groove depth.
3, the installation of metal decorative wood bottom support: the square wood is fixed on the ground, with all-purpose glue to stick the metal decorative panel on the wood. If aluminum alloy square tube is used, aluminum Angle can be fixed on the frame column, or wood screws can be fixed on the wood brick embedded in the ground.
4. Install vertical door frame: nail the door frame square wood with the center line of the play, then determine the shape and position of the door frame column with plywood, and finally outsource the metal decorative surface. When wrapping the finish, the decoration should be placed in the middle door position on both sides of the installation glass.
5, installation of glass: use glass sucker machine to suck thick glass, lift the thick glass plate to the installation position. Insert the upper part of the glass into the limit slot at the top of the door frame, and then put the lower part of the glass on the bottom bracket. In the bottom of the inner and outer nail two small square wood in the thick glass clip in the door, in the square wood coated with all-purpose glue and the decorative metal stick in the square wood.






