China ventilation fan motor suppliers,Power ventilator—a component of power ventilator
Impeller: 12 backward inclined wing-shaped blades are welded between the arc-shaped wheel cover and the flat-shaped wheel disc. The wing-shaped blades are used to ensure the high efficiency, low noise and high strength of the fan. The impeller runs smoothly after static and dynamic balance correction. The impeller structure of the fan and induced draft fan of the same machine number is the same.
Case: The case is a snail-shaped body welded with ordinary steel plates. The casing of the fan is made into an integral structure. For the induced draft fan, the ash-removing door is opened on the snail-shaped plate, and at the same time, it is appropriately thickened to prevent the soot from wearing out and prolong its service life.
Adjusting door: a device used to adjust the flow rate of the fan. Composed of 13 braided blades, all axially installed in front of the air inlet. Due to the external transmission structure, the rotation is flexible and convenient. The adjustment range is from 90° (fully closed) to 0° (fully open). Adjust the position of the handle of the door, looking from the direction of the air inlet, on the right side. For right-handed fans, push the handle from bottom to top from fully closed to fully open; for left-hand fans, pull the handle from up to fully open from fully closed to fully open.
Transmission group: It is composed of main shaft, bearing box, coupling, etc. The main shaft is made of high-quality steel. Adopt rolling bearing water-cooled integral bearing box. Therefore, a water delivery pipe needs to be installed, and the water consumption varies with the ambient temperature, generally 0.5~1m3/h. The bearing box is equipped with a thermometer and an oil level indicator.






