Gear box is more and more widely used in daily life. Our company provides high quality Chinese reduction box. Reducer plays the role of matching speed and transferring torque between prime mover and working machine or actuator.The purpose of using it is to reduce the speed and increase the torque.It has a wide variety of models, different types have different USES.There are many kinds of reducer, according to the transmission type can be divided into gear reducer, worm reducer and planetary gear reducer;According to the different transmission series can be divided into a single stage and multistage reducer;According to the gear shape can be divided into cylindrical gear reducer, bevel gear reducer and tapered - cylindrical gear reducer;According to the transmission layout can be divided into expansion type, diverter type and coaxial type reducer.
The correct installation, use and maintenance of the reducer is an important link to ensure the normal operation of the mechanical equipment.
1. When installing the reducer, pay attention to the alignment of the axis of the transmission center, and the error shall not be greater than the amount of compensation used by the coupling.It can prolong service life and obtain ideal transmission efficiency.
2. According to the prescribed installation device to ensure that the staff can easily access to the oil standard, ventilation plug, drain plug.After the installation is in place, the accuracy of the installation position should be checked comprehensively in order, the reliability of the fasteners should be pressed, and the fasteners should be able to rotate flexibly after installation.Oil splash lubrication is adopted in the reducer. Before operation, the user shall remove the screw plug of air vent and replace it with air plug.According to different installation positions, open the oil level plug screw to check the height of the oil level line, add oil from the oil level plug until the oil spills from the oil level plug screw, screw the oil level plug to confirm no error, then no load test can be carried out, the time shall not be less than 2 hours.The operation should be stable, no impact, vibration, noise and leakage of oil phenomenon, any abnormity should be removed in time.
