Brushed motor and brushless motor
However, the brush motor is bulky, bulky, low in power, short in life, and the carbon brush is easy to wear with a long time of work or excessive voltage, and the wear is very serious in a short time. Therefore, the current brushless motor has gradually replaced the brush motor.
The brushless motor does not have the same internal displacement device as the brush motor, and cannot work independently. It must have the cooperation of the commutator, that is, the brushless ESC can work. There is also an outer rotor motor in the brushless motor. This type of motor has good heat dissipation and a large number of magnetic poles. The torque is larger than that of the inner rotor motor and the rotation speed is low. Most of them are used in aircraft models and drones.
Brushless motors have a much longer life due to the absence of carbon brushes. In addition, the brushless motor speed is much higher than the brush motor speed. This also caused some problems. When the early brushless motor was first introduced, it was often used in conjunction with low-speed paddles, which often exploded and exploded. The blasting shell means that the motor speed is too high, and the motor casing bursts due to excessive centrifugal force, causing the magnetic block to fly out quickly. The explosion is similar, that is, after reaching a certain speed, the propeller flies out from the motor to the periphery due to centrifugal force or other force. In addition, the brushless motor uses an external electronic commutator, the commutation frequency is 8KHZ, and the frequency is very high, which also causes the motor power to increase a lot. Compared with the brush motor, the weight is also much lighter.
When the brushless motor gradually captured the drone market, it also led to the red fire and electric adjustment of another accessory. Since the brushless motor cannot work independently, it must be operated as a commutator to work, so the ESC market is also brought up.






