Feb 26, 2019 Leave a message

What is the purpose of tying the ends of the motor windings?

What is the purpose of tying the ends of the motor windings?

Whether it is the stator winding or the rotor winding, whether it is a soft winding or a hard winding, the end of the manufacturing process will be necessary to bind the end; theoretically, the purpose of the binding is to ensure the winding and winding, winding and insulation, winding The relative position of the associated components remains the same and contributes to the curing of the winding after dipping.

In order to achieve this, the heat-shrinkable insulating straps or lashing cords are used for the windings to ensure that the ends are in a relatively solid overall after the windings are dipped. However, the heat shrinkage of the tie wrap has a certain range, so a certain tension should be ensured during the tying process.

It should be emphasized here that for the problem of tying and fixing the leads, on the one hand, it is necessary to ensure that the leads cannot be freely moved after the tying, and on the other hand, it is ensured that the connecting portions of the leads and the wires are not pulled by the post-processing. For the above reasons, the binding of the ends of the windings must be standardized, and not just the entanglement of the form.

5

High-voltage motor end lashing application analysis

Since the windings of the motor are in phase and out of phase, the mutual attraction and repulsive force between the two bars of the adjacent coils at the ends will be generated. In order to avoid the displacement caused by the force, the end portions must be fixed as necessary. In the side gap between the adjacent winding bars, the polyester rope with the thickness close to the gap size is selected to be tightly tied.

At present, the high-voltage motor stator adopts VPI immersion process. The insulation structure is powder mica tape wrap coil, the end of the coil is tied with polyester glass rope, and the coil and end hoop are tied with rope, but it can not be too tight to prevent two The parts that are in contact with each other have insulation damage to varying degrees, which reduces the insulation performance. When the coil heats the rule according to the process requirements, the insulation near the end of the nose is softened. This damages the insulation and affects the service life.

Due to the large pitch of the high-speed motor and the large distance between the poles, the stator windings generally have the characteristics of long end length and large bell mouth. Some use large and small coils, and the inner circular coil at the end is wavy, and the gap between the lower and upper layers is extremely small. To this end, a layer of 4-5 mm thick polyester felt can be wrapped on the coil end hoop insulation to act as a gasket between the coils. Because the polyester felt is soft and has a certain amount of compression, the coil insulation that binds the wire is no longer depressed by the end band, and also increases the contact area of the lashing, ensuring that the coil is in close contact with the end band, and the winding After the lacquer is cured, it will facilitate the radial and tangential fixation of the ends.

If you want to buy a household appliance motor, please pay attention to Spinbrush Motor.

Send Inquiry

whatsapp

teams

E-mail

Inquiry