At present, the common ice crusher on the market is mainly a ice reprocessing and breaking device. Its working principle is to drive the blade to rotate at high speed through the power driven motor, so as to crush the ice to achieve the purpose of breaking ice.
How should the ice crusher operate?
First break the ice to a diameter of about 20 mm, then put into the cylinder, the upper side of the convex cylinder is appropriate. Note that the power switch is turned on first, and then the handle of the dynamic press cover of the plate is pressed down after the motor rotates with the power plate. At this time, the ice cubes are chopped by fastening the blade on the rotary knife plate. However, when the handle of the press cover is pressed down, it shall not be too hard to prevent the motor from blocking and damaging the motor. If it is a fully automatic shaved ice machine, just put the appropriate ice, cover the machine, open the switch can be. During operation, attention should be paid to the surplus after the reduction of ice, and the new ice block should be added in time.
Notes for use of ice shredder:
1. Used for mincing ice particles, through the discharge port into the tray, should pay attention to the discharge port discharge smoothly, can not be blocked, otherwise it will cause stuck knife head, burn out the motor. If the cutter head is found to be stuck, immediately lift the handle of the press cover, turn off the switch, pull out the plug, and troubleshoot the fault in time.
2. The thickness of ice can be by adjusting the height of the blade mouth bulging disc, shaved ice machine need to adjust the corresponding thickness switch can, if it is semi-automatic, to view the instructions, have a plenty of cannot open adjustment, such as can be, when need to adjust to remove the protection switch device of plastic tray, loosen screw fixed bend, pull out the cylinder, and then operate on the loose The fastening screw OF the disc, remove the cutter head, then loosen the pressing screw of the blade, install in place according to the required requirements, and then put the cutter head back in place in order.
3. The design transient rate of the motor is 80%, so it is necessary to avoid long-term continuous operation. After working continuously for one hour, you should stop for twenty minutes before you start working. This will greatly extend the service life of the motor.
4. After each use, it must be cleaned. When cleaning, it should turn off the main power switch, unplug the plug, and then wipe the water on the machine with a clean towel.
5. After cleaning, be sure to lift the handle of the press cover. Cleaning agents are not allowed to be used during cleaning to prevent contamination caused by residual cleaning agents on board. Also can not be directly washed with water, so as not to damp electrical parts, affect the safe use and damage the machine.
6. Whether cleaning, maintenance, blade replacement or cleaning ice slag and other related work, should first turn off the power supply, unplug the power plug; Shave ice is not allowed to run for a long time without load.
