Technical focus of installation of electromechanical equipment for automated control systems
In the construction process of the installation of electromechanical equipment of intelligent building automation control system, the technical and quality control of construction is the most important content, which is the most important factor affecting the service life of electromechanical equipment and the economic benefits of the whole enterprise. Under the brutal competition in the market, the installation of electromechanical equipment can further enhance competitiveness, and can effectively supervise the progress and quality of the project, so as to ensure the smooth completion of the project. In addition, for electromechanical enterprises, continuously improving the quality and technical level of products can effectively promote the development of enterprises and enhance their market position and competitiveness. Only the construction technology of electromechanical equipment installation can be optimized and improved, and at the same time assisting with good quality control, can promote the rapid development and progress of the enterprise.
Construction technology focus of mechanical and electrical equipment installation of automatic control system
1. Distribution box with low indoor installation pressure
In the interior of an intelligent building, a lower-voltage distribution box must be installed, and smooth and tidy paint should be applied to the surface of the distribution box. The sign of the distribution box should be placed in the most conspicuous position and fixed. The frame of the distribution box ensures that certain appliances will not be installed under the distribution box during installation. This method can effectively prevent the switchgear from causing a large amount of current to burn out the distribution box, causing a major safety accident. Therefore, when installing the distribution box, first configure a flame-retardant and explosion-proof equipment to ensure the safety of the distribution box.
2. Outdoor installation of rainproof power distribution box
When installing the distribution box outdoors in an intelligent building, fully consider whether the location of the distribution box is protected from rain or whether a rain cover can be installed. Assume that it is in a public place, but also how to install the fixed box door of the distribution box, and after the installation is completed, a lock is also required to ensure that the distribution box can operate normally and safely, avoiding human damage and other dangerous accidents. happened.
3. System installation of electromechanical equipment
In the installation process of the whole electromechanical equipment, the electromechanical system is the most critical installation link, and the quality of the installation directly affects the normal operation of the electromechanical equipment. Therefore, in the process of installation, it is necessary to carry out standardized operation in strict accordance with the installed standards and technologies. Before the electromechanical system is installed and before use, in order to ensure the normal operation and safety of the electromechanical system, the electromechanical system must be adjusted first. Test run so that good quality requirements can be achieved. The whole debugging process has four steps: one is the preparatory work before debugging, the other is the attempt to run the electromechanical system, the third is the debugging during the running process, and the fourth is to close the electromechanical system. Before commissioning, check the data to confirm whether the environmental conditions meet the trial operation of the electromechanical equipment, and check whether the power storage system supports the normal operation requirements of the electromechanical system. Only by coordinating these four steps can we detect whether the electromechanical equipment meets the operational requirements and quality of the standard electromechanical system.
