Structure of mixer

The main structure of the mixer is motor, reducer and frame; Mixer contains coupling, rotor, blades, etc., this page for the most simple structure shows as follows: the selection of A motor: the motor in addition to the input power of the Z basic conditions, when should pay attention to the installation environment, including indoor and outdoor and flash fire conditions, physical properties of blend respectively indicate the room type, room exterior, explosion-proof grade condition (safety explosion protection or pressure); Even for pneumatic motors, etc. B Reducer: Due to the variety of reducer, structure and efficiency values are similar, the relative price difference is also large, installation method and site space may also be limited. C frame: Due to the intense dynamic load in liquid mixing, the motion stability and life of the mixer depend on the structure of the supporting frame. The conditions such as speed, viscosity and capacity will be considered. D Mounting plate: The flange surface directly in contact with the barrel groove is easy to be corroded by liquid splashing and gas, so the choice of material is extremely important. E shaft seal: Pressure vessels, reaction tanks and toxic, odor and other containers must be isolated and air tight, generally can be mechanical shaft seal, Gran shaft seal, oil seal or special compound isolation equipment. And the full consideration of its applicable material, maintenance and operation process cooling conditions. F coupling: The stable movement of the drive shaft and the agitator is connected. We provide CF type lug coupling with strong structure, which enables the agitator to be firmly and linearly combined with the agitator. CO type casing is also available for light stirring equipment. Special use and can be designed for special rapid disassembly design. G Stirring shaft: solid shaft or pipe can be used in the straightening place. In high speed environment can be used for finishing or grinding, to assist customers to choose the most appropriate material, design the best axis and diameter matching, and with polishing or lining processing. H Stirring blade: The choice of agitator blade determines the mixing effect.