Stepper motor factory with complete models, professional quality, high visibility, fast delivery, world famous supplier.
1. Stepper motor should be used in low-speed situations -- the speed is not more than 1000 revolutions per minute (0.9C, 6666PPS), and it is best to be used between 1000-3000PPS(0.9C). It can be made to work during this period through the reduction device.
2. It is better not to use the whole step state for the stepping motor, because the whole step state has large vibration;
3, due to historical reasons, only a nominal for the 12 v voltage of motor using 12 v, the other motor voltage value is not driving voltage v, can choose according to drive the driving voltage (suggestion: 57 byg adopts dc 24 v and 36 v, 86 byg adopts dc 50 v, 110 byg USES the above dc 80 v), 12 volts, of course, in addition to the 12 v constant voltage driver can also be driven by other power supply, but want to consider temperature rise;
4. Motor with large frame size should be selected for load with large moment of inertia;
5. When the motor is at a relatively high speed or large inertia load, it is generally not started at the working speed, but gradually increases frequency and speeds up. One motor does not lose step, and the other can reduce noise and improve the positioning accuracy of stopping.
6, high precision, should be through the mechanical deceleration, improve the motor speed, or the use of a high fine fraction of the driver to solve, can also use 5 phase motor, but the price of the whole system is more expensive, less manufacturers, its phased out is a layman's jargon;
7. The motor should not work in the vibration zone. If necessary, it can be solved by changing the voltage, current or adding some damping.
8. The motor works below 600PPS(0.9 degree), and should be driven by small current, large inductance and low voltage;
9, should follow the principle of selecting the motor before selecting the drive.
