Dec 12, 2018 Leave a message

Influence of DC Bus Voltage on Servo of Permanent Magnet Synchronous Motor

Influence of DC Bus Voltage on Servo of Permanent Magnet Synchronous Motor

At present, in the domestic market, small and medium power AC servos generally adopt the "AC-DC-AC" variable voltage frequency conversion topology. The AC power is rectified to DC, and the DC is inverted by the controllable power component to the three-phase power required by the motor [1]. Among them, the input of the AC power supply is generally 3 phase 220v (phase voltage is 220v). When the motor power is small, the input of the AC power supply is generally single-phase 220v. In the case of inverter, the on-time of each switching tube is calculated from the reference of the DC bus voltage. In many cases, the DC bus voltage vdc is constant in program calculations. In practice, the magnitude of the DC bus voltage is fluctuating. Since the pi control is used in the control of the current loop, the fluctuation of the bus voltage cannot affect the final adjustment result, but it has a certain influence on the adjustment time and the dynamic tracking accuracy. Especially when the value of the DC side capacitor is small and the load is heavy, the effect is obvious.

This paper verifies the above viewpoint in the case of single-phase 220v power supply and large load. Through comparison experiments, it is verified that the bus voltage compensation method can improve the performance of the driver at a given speed step.

The root cause of the bus voltage problem

The main circuit of the permanent magnet synchronous motor AC servo control system consists of a rectifier circuit, an intermediate DC circuit and an inverter power tube.

If the capacitor energy storage and filtering of the DC circuit are ignored, the bridge rectifier waveform of the single-phase AC 220v is shown in Figure 2 [2]. The waveform frequency is twice the power frequency of 100hz. The bridge rectification waveform of the three-phase AC 220v (phase-to-phase amplitude is 220v) is shown in Figure 3, and the waveform frequency is 300hz.

In practice, because of the energy storage and filtering of the DC side capacitor, the DC bus voltage is stable at around 311v without the motor having high power consumption. When the motor needs high power consumption, it can be seen from the figure that the single-phase 220v power supply performance will be far less than the three-phase 220v power supply. However, in some cases, the supply of power is limited to a single phase 220v due to conditions. This causes the problem of fluctuations in the DC side bus voltage.

Experiments show that the program is reasonable and feasible. Although the performance improvement of the drive is limited, the method is feasible when higher requirements are placed on the servo drive. In addition, as a designer to fully consider the motor output power, power supply power and power supply conditions to select the DC bus capacitance value to ensure that the bus voltage has a strong anti-disturbance capability.

TW-7712D

Send Inquiry

whatsapp

teams

E-mail

Inquiry