Scrubbers, a common cleaning equipment product, have now been largely popularized. We can meet them in our daily necessities of life. The increased utilization rate will inevitably increase the failure rate and maintenance rate. Although the usage rate has increased, there are still many people who do not understand its working principle and maintenance methods. Today I mainly talk about the problem of water absorption motor damage.
The damage of the water absorption motor is mainly manifested in two aspects. One is the carbon brush, and the other is the damage to the water inlet bearing. Because the carbon brush is a wear part, it is not likely to be damaged during normal use. If the frequency of use is not too high, there will be no problem in three or four years. After three or four years, you only need to replace the carbon brushes. Of course, the premise is that the suction motor does not enter the water. The problem of water intake in the water suction motor is currently a very common problem in the industry. The reason is that the washing machine is considered in terms of structural design and cost. I have to complain about some big international brands here, so I won't mention them. Their machines are often 30,000 to 50,000. The machine at this price uses the cheapest design, which is really taking the country for a fool. The same is true for some domestic machines, both low-end and high-end.
Anyone who knows the structure of the washing machine should be clear. The most economical way is to connect the suction port of the suction motor directly to the sewage tank of the washing machine. This structure is really super cost-effective in terms of manufacturing and cost savings. But his problems will soon arise. There is foam in the sewage tank, and the operation of the sewage tank exceeding the water level will cause water to enter the suction motor. Because the water absorption motor belongs to the series excitation motor, the speed can reach more than 10,000 revolutions per minute. The requirements for its bearings are very high. There is water in the fan blades of the motor, and it will naturally enter the bearing. Bearings are precision parts. In this case, I don't need to explain them. Everyone should be able to understand them.
How to avoid this problem from happening? Jieyoude cleaning equipment network recommends several methods for you. See below.
1: When purchasing a washing machine, pay attention to the structure of the suction motor. The water suction motor of Jieyoude washing machine has been optimized, and now there is no water at all. Of course don't ask how to do it, it's a corporate secret. We can guarantee that the water absorption motor of the washing machine is damaged by water, and all of them will be replaced free of charge.
2: Don't worry if you are unfortunate enough to buy a machine with a direct connection structure. When using it, try to do as much as possible: drain frequently, check frequently, and add less water. The first two are well explained. Talk about adding less water. Just add less water to the clean water tank. Because the tank capacity is fixed. The more you add to the clean water tank, the more the sewage tank will naturally be. Add less, and the sewage tank will be charged less, so that the water level will not be exceeded.
3: Sewage tank liquid level alarm. This is also very important. With it, there will be no over-water usage.
Having said so much, it is nothing more than those few meanings. After you understand it, you will know exactly what equipment you want in terms of use and purchase selection. To sum up: most of the reasons for the damage of the water suction motor are water ingress. The early phenomenon of water ingress is that the sound is sharp when working. People who use it often can understand that the machine is not normal after listening to it. At this time, you should stop using the machine in time. Ask an after-sales or maintenance technician to remove the water absorbing motor and replace the bearing. This can effectively solve the problem. At the same time, there is no need to replace the suction motor.
