Jan 26, 2019 Leave a message

Forming and gelling of high voltage motor coils

Forming and gelling of high voltage motor coils

Compared with most low-voltage motors, high-voltage motor coils use hard windings. The hard windings must be formed before the weaving. The high-voltage motors use the special characteristics of the electromagnetic wires and require gelation. Ms. Join us today to share with you the contents of coil forming and gelling.

The in-line winding is shaped by the edge of the ruled line during the inlay process, and the necessary shaping is performed on the end after the winding completely enters the core. However, there is no shaping process in the forming process of the forming coil, and even if it is only a small range of fine adjustment, the forming of the coil is very important, and it is necessary to ensure that the coil is embedded in the iron core to meet the requirements. In order to improve the processing efficiency and quality of the coil, the conditional motor manufacturer adopts the automatic molding process, so that the consistency of the coil is very good, as long as the input coil parameters are all Ok.

Gelatinization is a special process for a gelled insulated electromagnetic wire. The gelation process melts the glue in the insulation by heating, and then bonds the tantalum and niobium together to form a curing effect on the strand. It can also enhance the vibration resistance of the motor.

Gelation process description

At a certain temperature, the solvent-free paint changes from a viscous liquid to a gelatinous elastic material, and the properties are also abrupt. This phenomenon is called gelation, which is called gelation. When the gel begins to appear, the gel consists of two different molecular structures. One is a polymer with a network structure, which has insoluble properties, so it is called a gel. The other is a sol having a lower molecular weight which is enveloped in the network of the gel. Under the action of temperature, the gel continues to react, the sol fraction gradually decreases, the gel fraction gradually increases, the elasticity and toughness of the gel composition increase, and finally the cured product is obtained.

If the gelled insulated magnet wire is placed for too long, failure may occur. The most direct effect is that the gelling process cannot achieve mutual bonding. Therefore, during the production process of the high voltage motor, the purchase of the magnet wire must be limited to prevent Cause unnecessary waste.

If you want to buy a vacuum cleaner motor, please pay attention to AC Powerful Cleaner Motor.

Send Inquiry

whatsapp

teams

E-mail

Inquiry