Jan 15, 2019 Leave a message

Dielectric loss of insulating materials

4. Dielectric loss of insulating materials

Under the action of an electric field, the insulating material generates energy loss due to leakage and polarization. The loss power or loss tangent is generally used to indicate the dielectric loss.

Under the action of the DC voltage, the instantaneous charging current, the sinking current and the leakage current flow will pass. When an alternating voltage is applied, the instantaneous charging current is a reactive current (capacitor current); the leakage conducting current is in phase with the voltage, which is an active current; and the sinking current has both a reactive current component and an active current component. The main factor affecting the dielectric loss of insulating materials.

● Frequency. When the temperature is constant, the loss tangent peaks at a certain frequency, and the dielectric loss value P per unit volume increases the fastest.

Since there are different dielectric losses at different frequencies, a certain frequency must be selected when measuring the loss tangent. Generally, the materials used in the motor are generally measured as the dielectric loss tangent of the power frequency.

● Temperature. When the frequency is constant, the loss tangent shows a peak at a certain temperature, and the loss caused by the absorbed current is the largest. In the low temperature region, the active components of the leakage current and the absorption current are small, so the loss tangent is small; in the high temperature region, the loss due to the absorption current disappears, which is determined by the leakage loss.

For some organic insulating materials, the loss tangent may have several peaks at different temperatures or frequencies. Therefore, in high-frequency or high-voltage electrical equipment, the appropriate insulation material should be carefully selected according to the loss tangent and temperature and frequency curves to avoid loss tangent peaks at the operating frequency and temperature to prevent accelerated aging or thermal shock. wear.

● The electric field strength increases. The loss tangent also increases. When the voltage increases to a certain value, the bubble inside the medium or the edge of the electrode will be partially free, and the loss tangent will suddenly increase significantly. This voltage value is called the initial free voltage. Engineering always uses the measurement of the initial free voltage to check the air gap existing inside the insulation structure to control the insulation quality.

In addition, some insulating materials should also consider electrical properties such as corona resistance, arc resistance, and leakage tracking.

The electrical performance requirements of the motor for the insulating material are the most important for breakdown electric field strength and insulation resistance. Depending on the type of motor, other electrical performance requirements are not exactly the same. For example, the insulation of high-voltage motors requires less dielectric loss and corona resistance. The electric field distribution between the core and the conductor must be considered.

If you want to buy a medical device motor, please pay attention to Small Linear Actuator.

Send Inquiry

whatsapp

teams

E-mail

Inquiry