Detailed analysis of the advantages and disadvantages of five kinds of driving methods for stepping motors
The development of drive technology, from the original foreign ones to the emergence of various domestic excellent technologies, can be seen in the progress of domestic technology, but also can be seen that every technological innovation will bring several market revolutions to guide the market with high-end technology. 1, constant voltage drive
Single-voltage driving means that during the operation of the motor winding, only one direction voltage is used to supply power to the winding, and multiple windings alternately supply voltage. This method is an older driver, and it is basically no longer needed.
Advantages: simple circuit, few components, simple control, simple to implement
Disadvantages: It is necessary to provide a triode with a large enough current for switching processing. The stepping motor has a relatively low running speed, the motor vibration is relatively large, and the heat is large. Since it is no longer used, it is not described much.
2, high and low voltage drive
Due to the above-mentioned shortcomings of the constant voltage drive and the further development of the technology, new high and low voltage drives have been developed to improve some of the shortcomings of constant voltage driving. The principle of high and low voltage driving is to use high voltage control when the motor moves to the whole step. Use low pressure control when moving to half step, and use low pressure to control when stopping.
Advantages: High and low voltage control improves vibration and noise to a certain extent. For the first time, the concept of step-by-step control of stepping motor is proposed, and the working mode of halving current at stop is also proposed.
Disadvantages: The circuit is relatively complex with constant voltage driving, and the high-frequency characteristics of the triode are required to be improved. The low-speed motor still vibrates relatively loudly, and the heat is still relatively large. Basically, this driving mode is not used.
3. Self-excited constant current chopper drive
The self-excited constant current chopper drive works by hardware design. When the current reaches a certain set value, its current is turned off by hardware, and then the other winding is energized, and the current of the other winding is energized to a certain fixed. When the current is current, it can be turned off by hardware, and so on, the stepping motor is driven.
Advantages: The noise is greatly reduced, the speed is improved to some extent, and the performance is improved compared with the first two.
Disadvantages: The circuit design requirements are relatively high, the circuit anti-interference requirements are relatively high, easy to cause high frequency, burn out the drive components, and the component performance requirements are relatively high.
4. Current comparison chopper drive (currently the main technology used on the market)
The current comparison chopper drive converts the stepper motor winding current value into a certain proportion of voltage, compares it with the preset value of the D/A converter output, and compares the result to control the power tube switch to achieve the control winding phase current. purpose.
Advantages: The motion control simulates the characteristics of the sine wave, greatly improves the performance, the motion speed and the noise are relatively small, and the relatively high subdivision can be used, which is the currently popular control method.
Disadvantages: The circuit is more complicated, it is difficult to control the interference in the circuit and the theoretical requirements are consistent, it is easy to produce jitter, and the peaks and troughs that form the sine wave are controlled, which easily lead to high-frequency interference, which leads to the heating of the driving component or the frequency is too high. Aging, which is the main reason why many drivers are prone to red light protection when they are used for more than a year.
5, submersible drive
This is a brand new motion control technology, which is a new driving method that is innovative under the premise of current current chopper driving technology to overcome its shortcomings. The core technology is to increase the driving element heating and high frequency suppression protection technology under the premise of current comparison chopper driving.
Advantages: In addition to the advantages of current comparison chopper drive, the heat is particularly small and the service life is long.
Disadvantages: The new technology, the price is relatively high, the current matching requirements for each stepper motor and driver are relatively strict.






