Jun 24, 2020 Leave a message

China motor universal suppliers

We are a China motor universal suppliers,Preparation and inspection before startup:

1. Check whether the grounding of electric and starting equipment is reliable and complete, and whether the wiring is correct and good.

2. Check whether the voltage and frequency shown on the motor nameplate are consistent with the voltage and frequency of the power supply.

3. Before starting the newly installed or long-used motor, check the winding relative phase and relative insulation resistance.The insulated group shall be greater than 0.5 megohm. If the value is lower than this, the windings shall be dried.

4. For the wound rotor, check whether the brush device on the collector ring can work normally and whether the brush pressure meets the requirements.

5. Check whether the motor is flexible in rotation and whether the oil in the sliding bearing reaches the specified oil level.

6. Check whether the rated current of the fuse used in the motor meets the requirements.

7. Check whether the tightening bolts and mounting bolts of the motor are tightened.

After all the above inspections meet the requirements, the motor can be started.After the motor is started, it should run for about 30 minutes without load. Pay attention to observe whether there are abnormal phenomena in the motor. If abnormal conditions such as noise, vibration and heat are found, measures should be taken.

When starting a wound motor, the starting rheostat should be connected into the rotor circuit.For motors with brush lifting mechanism, put down the brush, disconnect the short-circuit device, close the stator circuit switch and pull the rheostat.When the motor is close to the rated speed, lift the brush, close the short-circuit device, and the motor is started.

TW-UM4620

Send Inquiry

whatsapp

teams

E-mail

Inquiry