China Fan Motor 120V instructions
1. When you use the motor, there should be no binding objects. For example, the adhesive should not flow into the bearing through the rotating shaft, which will hinder the operation of the motor.
2. The rotation of the shaft may have the opposite effect on the service life of the motor. In order to prolong the service life, please check whether your load is in accordance with the regulations, and do not overload it, or there is something harmful to the rotation hanging on the shaft end.
3. It is manufactured into eccentric heavy radiation load, which is harmful to the service life of motor.
4. Do not store in the surrounding high temperature or extreme humidity, or in the corrosive gas, which will reduce the motor effect.
5. Do not operate the motor in the surrounding high temperature and humidity.
6. When soldering is required on the motor terminals of the positive and negative poles of the power supply, the temperature of the soldering iron shall be 340 ± 40, and the heating time shall be within 3 seconds, and the plastic shall not be deformed. During the operation, let the solder point flow into the motor or break the end of the wire, which will make the motor function decline.
7. Do not let the motor shaft get stuck. When power is introduced, it will overheat the motor in a short time and burn its accessories.
8. Due to the lack of skills of the staff, the quality of the motor cannot be guaranteed in case of any matter mentioned in the manual, or when the apparent judgment is obviously negligent.
9. Supply the specified power and make sure it is within the measurable requirements.
10. The installation of pulley or gear shall not be abnormally weighted during pressing.
11. When installing the motor, if the screw is too long, it will cause contact between the motor itself and the rotor, which will affect the characteristics.
