China 12v Gear Motor factory tells you the terminology of geared motors
Purchasing personnel and engineering personnel will inevitably encounter some terminology about the product when communicating with the gear reducer sales personnel. Familiar with these terms can not only reflect your professionalism, but also improve the efficiency of the work and reduce the wrong type of speed reducer. The possibility of the number.
1. Reduction ratio: It is also called speed ratio. It is a very important parameter of the reducer. His calculation method is: reduction ratio = input speed / output speed. The standard speed reducers are 1:1, 1:2, 1:3, 1:4, 1:5, 1:10, 1:15, 1:20, 1:25:1:30, 1:35. 1:40... So in the analogy, some companies will also adjust the speed reducer according to the customer's needs.
2, P (power): Many engineers will say a few P and a few P reducer, in fact, this is power, 1 / 8P is 100W, 1P is 750W, 2P is 1500W ... and so on.
3. Rated torque: It is the long-running torque allowed by the rated life. When the output speed is 100 rpm, the life of the reducer is the average life. When this value is exceeded, the average life of the reducer will decrease. The gear unit fails when the output torque exceeds twice.
4. Noise value: The unit is decibel dB(A). Under normal circumstances, the noise of the geared motor is about 70 dB(A), which meets the requirements of daily industrial machinery, that is, it meets the national standard.
5. Hysteresis: Fix the input end so that the output end rotates clockwise and counterclockwise. When the output end is subjected to plus or minus 2% of rated torque, the output end of the reducer is displaced by a slight angular displacement. This angular displacement is the return stroke. The gap, also known as the "backlash". The unit is "minute", which is 1/60 of the first degree.
6. Frame No.: The frame number is also called the output shaft size. The frame number of the geared motor is divided into two types: the national standard frame number and the reduced frame number. In actual cases, a reduction gear reduction gear motor may be used due to limited installation space or in order to reduce costs. However, the reduction frame motor is generally less than the standard frame number motor, so if there is no full grasp, it is recommended not to use the frame motor.






