Nov 06, 2020 Leave a message

buy stepmotor

Buy stepper motor is an open-loop control element that converts electrical pulse signals into angular displacement or linear displacement.In the case of non-overload, the motor speed, stop position only depends on the pulse signal frequency and pulse number, and is not affected by the load change, that is, to add a pulse signal to the motor, the motor will turn a step Angle.The existence of this linear relationship, coupled with the stepper motor only periodic error and no cumulative error and so on.It makes it very simple to use stepper motor to control speed, position and other control areas.

1. Stepper motor is used in low-speed situations -- the speed is not more than 1000 revolutions per minute, and it can be used between 150-450rpm. It can be made to work here through the reduction device, with high working efficiency and low noise.

2, due to historical reasons, only a nominal for the 12 v voltage of motor using 12 v, the other motor voltage value is not driving voltage v, can choose according to drive the driving voltage (suggestion: 42 motor use dc 12 v and 24 v, 57 motor adopts dc 24 to 36 v), 12 volts, of course, in addition to the 12 v constant voltage driver can pick in other drive power supply, but want to consider temperature rise.

When the motor is at high speed or large inertia load, it is generally not started at working speed, but gradually increases frequency and speeds up, one motor does not lose step, two can reduce noise and improve the positioning accuracy of the stop.

3, high precision, should be through mechanical deceleration, improve the motor speed, or use a high fine fraction of the driver to solve.

4, the motor should not work in the vibration zone, if necessary by changing the voltage, current or add some damping to solve.

5. The motor works below 90RPM, and should be driven by small current, large inductance and low voltage.

 TW-57HC


Send Inquiry

whatsapp

teams

E-mail

Inquiry