Aug 07, 2020 Leave a message

buy asynchronous motor

When buying asynchronous motor, we often encounter the following problems. The motor vibrates greatly during operation.

1. Failure reasons: (1) The bearing clearance is too large due to wear;(2) Uneven air gap;The rotor is unbalanced;The shaft is bent;Deformation or looseness of the core;6 coupling (belt pulley) center is not calibrated;Fan unbalanced;The shell or basic strength is not enough;Pet-motor base screws are loose;Liliate cage rotor open welding circuit;The wound rotor is broken;Failure of stator winding.

2. Troubleshooting: (1) Overhaul the bearing and replace it if necessary;(2) Adjust the air gap to make it even;(3) Correction of rotor dynamic balance;(4) aligning shaft;(5) Correction of overlapped cores and recalibration to make them conform to regulations;Maintenance fan, adjust the balance, correct its geometry;8) to reinforce;Pet-type fastening anchor screws;

Attended repair of rotor winding;Repair stator winding.

And the motor has abnormal noise and abnormal noise during operation.

1. Fault causes: Friction between rotor and stator insulating paper or groove wedge;(2) Bearing wear or foreign matter such as sand in the oil;(3) fixed rotor core loose;The bearing is short of oil;(5) Air duct stuffing or fan cleaning wind cover, fixed rotor iron core rub;Too high or unbalanced power supply voltage;The stator winding is staggered or short - circuit.

2. Troubleshooting: (1) Trim insulation, cut low groove wedge;(2) Replace the bearing or clean the bearing;(3) maintenance fixed, rotor core;(4) come on;Clean the air duct;Reinstall;Eliminate scratches, if necessary, the small rotor inside the car;Check and adjust the power supply voltage;The stator winding fault is eliminated.

微信截图_20200807162139

Send Inquiry

whatsapp

teams

E-mail

Inquiry