Attention to the use of Customized Long Life Dc Motor
Attention to micro reduction Motors:
-When unplugging, do not pull the plug or there is a risk of electric shock or fire.
-Use the combination specified by the motor and the control device, otherwise there is a risk of fire.
-Set parameters according to the type of machine before connecting to the machine, otherwise there is a risk of injury.
-When working in connection with a machine, set it at any time to allow for an abnormal stop, otherwise it is likely to cause personal injury.
-In the event of an anomaly, please cut off the power immediately, otherwise there is a risk of electric shock, injury, and fire.
-In operation, please do not touch the rotating body(output shaft), otherwise there is a risk of being involved in the machine, causing personal injury.
-Please do not touch the motor or control device with your hand or body after running, otherwise you may be in danger of being burned.
-Avoid the use of machines in environments that are explosive, flammable, corrosive, potentially water-sensitive, and flammable. Or there's the risk of electric shock, injury, fire.
-Please do not move, touch, and check the machine while it is plugged in. Please do this after cutting off the power.
-Check the machine on the basis of a wiring diagram, otherwise there is a risk of electric shock and fire.
-Please do not overbend, pull, and plug the power cord and wire, otherwise there is a risk of electric shock and fire.
-When installing the motor and control device on the machine, be careful not to install the place easily touched by the hand. Or there will be electric shock, the danger of fire.
-Please do not run the machine in case of leakage of electricity, otherwise there is a risk of electric shock.
-Please cut off the power during power failure or overheat protection. Otherwise, sudden restarting can easily lead to injury, which is the risk of damage to the machine.
-The electric brake after the connection brake device can not stabilize the load. Additional safety measures should be taken when using the safety brake device. Otherwise there is a risk of injury and damage to the machine.
-Do not touch the output terminal of the control device for 30 seconds after power is cut off, otherwise it may be electrocuted due to residual voltage.






