Application of stepper motor in material metering
The application of stepping motor in material metering mainly shows the following aspects:
1. Measurement of powdered materials
Screw metering is a commonly used volumetric metering method. It is how much the metering is achieved by the number of turns of the screw. In order to achieve the purpose of adjustable metering size and improved metering accuracy, the screw speed is adjustable and the position is accurately positioned. The motor can meet both of these requirements.
For example, the metering machine uses a stepping motor to control the speed and number of revolutions of the screw, which not only simplifies the mechanical structure, but also makes the control very convenient. In the case of no overload, the speed and stop position of the stepping motor depend only on the frequency of the pulse signal and the number of pulses, and are not affected by the load change, which has obvious accuracy compared with the screw meter controlled by the electromagnetic clutch. Advantages, more suitable for material measurement with a large change in specific gravity.
The stepping motor and the screw adopt a direct connection method, and the structure is simple and the maintenance is convenient. It is worth pointing out that, as the overload capability of a stepper motor is relatively large, when there is a slight overload, considerable noise will appear. Therefore, after the measurement condition is determined, a larger overload factor is selected to ensure the stepping motor balance work.
2. Measurement of viscous materials
Stepper motor control gear pumps can also achieve accurate metering. Gear pumps have been widely used in the delivery of viscous bodies, such as syrup, bean paste, white wine, oil, ketchup and the like. At present, piston pumps are mostly used for the measurement of these materials, and there are disadvantages such as difficulty in adjustment, complicated structure, inconvenient maintenance, large power consumption, and inaccurate measurement.
The gear pump metering is measured by a pair of gear meshing rotations, and the space of the material passing through the teeth and teeth is forcibly sent from the feed port to the discharge port. The power comes from the stepping motor. The position and speed of the stepping motor are controlled by the programmable controller, and the measurement accuracy is higher than that of the piston pump.
The stepper motor is suitable for running at low speed. When the speed is increased, the noise of the stepping motor will increase significantly, and other economic indicators will drop significantly. For a gear pump with a relatively high speed, it is better to use a speed-up structure. We started to use the structure of the stepper motor direct-coupled gear pump on the viscous packaging machine. As a result, it is difficult to avoid noise and reliability. Later, the spur gear speed-up method was adopted to reduce the speed of the stepping motor, the noise was controlled, the reliability was also improved, and the measurement accuracy was guaranteed.






